|
|
| |
|
|
| Question 1 |
|
The LCD is faint. |
| |
|
|
| |
|
1. Set the LCD contrast to a higher level.
2. Replace the batteries
|
| |
|
|
Section 2 - Temperature/Humidity
|
| |
|
|
| Question 1 |
|
No outdoor temperature is displayed |
| |
|
|
| |
|
- Remove all batteries, reinsert into the remote temperature sensor first, then into the indoor weather station.
- Place remote temperature sensor closer to the indoor weather station.
- Be sure all batteries are fresh.
- No other interfering sources are being used (such as computer monitors, TV sets, headphone, or speakers) in the vicinity. The signal travels in a straight line, and electrical source near that "line" may cause interference.
|
| |
|
|
| Question 2 |
|
Temperature or air pressure is incorrect |
| |
|
|
| |
|
- Check/Replace batteries
- If multiple remote sensors are in use, check location with corresponding "boxed numbers."
- Move away from sources of heat/cold.
- Adjust relative air pressure to a value from a reliable source(TV, radio, etc.)
- The indoor weather station and remote sensors are calibrated at the factory. If there is a consistent problem, please contact us via email at support@lacrossetechnology.com or by phone at 1-888-211-1923
|
| |
|
|
Section 3 - WWVB Time and Date
|
| |
|
|
| Question 1 |
|
WWVB time and date will not set or update |
| |
|
|
| |
|
- Wait until overnight for signal to be received
- Move indoor weather station away from sources of electricity
- Place indoor weather station in window facing Colorado
- The first reception is most difficult, as the indoor weather station needs five continual minutes of clear signal reception. After the initial time/date set, the indoor weather station only requires one full minute of clear reception each night.
If there is a consistent problem, please contact us via email at support@lacrossetechnology.com or by phone at 1-888-211-1923 |
| |
|
|
