TX2U

Q: How can I get outdoor temperature to show on the display?

A:

1. Bring both units inside and have the units 3-5 feet apart with nothing in-between them.
   
2. Remove the batteries from both units.
   
3. Press one of the buttons at least 20 times or until the display is blank to clear all memory.
   
4. Put the batteries back into the remote sensor.
   
5. Taking care not to press any buttons, reinstall the batteries in the display.
   
6. . Do not press any buttons for at least 10 minutes after installing the batteries. (Let them establish a good connection.)
   
7. An outdoor temperature should be showing on your display. You can now put your outdoor sensor back outside.

Q: Does the remote transmitters have any trouble transmitting through specific materials?

A: Yes and No. We have trouble maintaining a signal through metal siding, stucco walls, and UV glass. You can get the remote sensor to transmit through these materials, but it will take a little bit of trial and error. Reset the weather station as mentioned above and change the angle that the remote transmits through the siding or glass until an outdoor temperature remains on the display for an extended period of time. Keep in mind that the signal from the remote must travel through some space (3 inches of air minimum) before reaching the metal wall or glass window.

Q: Where can I mount the remote sensor?

A: In order to get an accurate reading and to prolong the life of your sensor we recommend that you have it in a sheltered area out of the sun and direct rain. Fog and Mist will not affect the sensor, but a soaking in water may. You can mount it outside under an eve of your house or any other suitable place that will keep it out of the sun and rain. Do not wrap the sensor in plastic or seal it in a plastic bag.